CONTENTS

LEGEND

ORDERING INFORMATION

ELBOWS

TEES

LATERALS

CROSSES

Y BRANCH RECTANGLE TO ROUND,
REDUCER &
OFFSET

BELLMOUTH, COUPLING, ANGLE RING & END CAPS

CURVED SADDLES, FLAT SADDLES, SPUN INSIDE: OUTSIDE COUPLING, SPUN INSULATION END & SPUN REDUCER

CLAMP ACCESS DOOR & DUCT CONNECTIONS

LATERALS

L-1(L-2)

Specify:
Type: L-1 (one tap)
L-2 (two taps)
Diameter A
Diameter C
(Diameter D)
IF two taps, both taps
are in line on one side
and separated by 2"

LATERAL
45°
V=1.41 +2" for L-1
V=1.41 (C=D)+4"
for L-2
S=2"

L-1R(L2R)

Specify:
Type: L-1R (one tap)
L-2R (two taps)
Diameter A
Diameter B
Diameter C
(Diameter D)
IF two taps, both taps
are in line on one side
and separated by 2"

REDUCING LATERAL
45°
V=1.41 C+4" for L-1R
V=1.41 (C+D)+4"
for L-2R
L=A-b(4"min. and
and 12"max)
S=2"

CON-L-1 (CON-L-2)

Specify:
Type: CON L-1
            (one tap)
          CON L-2
            (two taps)
Diameter A
Diameter C
(Diameter D)
IF two taps, both taps
are in line on one side
and separated by 2"

CONICAL LATERAL
45°
V=1.41 (C+2")+2"
for CON-L-1
V=1.41 (C+D+4")+4"
for CON-L-2

S=2

CON-L-1R(CON-L-2R)

Specify:
Type: CON L-1R
            (one tap)
          CON L-2R
            (two taps)
Diameter A
Diameter B
Diameter C
(Diameter D)
IF two taps, both taps
are in line on one side
and separated by 2"

CONICAL LATERAL
REDUCING
45°
V=1.41 (C+2")+4"
      for CON-L-1R
V=1.41 (C+D+4")+6"
        for CON-L-2R
L=A-B(4"min. and
         and 12"max)
S=2"

LC-2 (LC-2R)

Specify:
Type LC-2 (LC-2R)
Diameter A
Diameter C
Diameter D

If angle between
taps is other than
180°, provide a sketch.

LATERAL CROSS
180°
Lateral Angle 45°
V=1.41 Largest Tap +2"
S=2"